How can we help?
-
Guides
-
Examples
-
- Dipole Antenna
- Half-Wave Dipole
- Folded Dipole
- Top-Loaded Short Monopole
- Monopole Above Earth Ground
- Radio Mast Above Wire Screen
- Square Loop Antenna
- Receiving Loop Antenna
- Magnetic Loop Antenna
- ISM 433MHz Helical Antenna
- Multiband J-Pole Antenna
- Modeling a J-Fed 5-Element Collinear Antenna for the 2 m Band
-
Validation
< All Topics
Print
Enabling/Disabling Loads
Updated
All the loads can be enabled or disabled at the same time. This option avoids deleting the load impedances when loads must not be considered in a simulation.
Go to Setup tab > Settings panel > in the main window. If the option Load Impedances is checked, the loads are enabled, otherwise they are disabled, Fig. 1.

Table of Contents